Applying conditioner is a well-known (and often much needed) element of your haircare routine. But have you been getting the best out of it? Let’s make sure from now on, you’ll master your conditioner application – our step-by-step instructions are here to guide you.
Watch our tutorial
STEP BY STEP
STEP 1
Squeeze the water out
Gently squeeze your hair to remove any excess water, so your conditioner stays put.
STEP 2
Use 1-2 pumps
Apply 1-2 pumps to your hair, depending on length. Start with a smaller amount and top up if your hair needs more!
STEP 3
While applying, detangle your hair with your fingers
Run the conditioner through your hair, focusing on your lengths and ends.
STEP 4
Rinse thoroughly
Time to be brave! Ready for an icy blast? Cold water closes your hair’s cuticles for a shiner finish.
Did you know?
Your SalonLab&Me Conditioner can also be used as a Leave-in, if your hair needs an extra bit of care! Follow our steps below to ensure the best application and results.
Watch our tutorial
STEP BY STEP
How best to apply your SalonLab&Me Conditioner as a Leave-in
STEP 1
Gently dry your hair with a towel
Wrap your hair in your favourite towel and begin to gently dry. Be careful – rubbing too hard can cause damage. Try tapping motions instead. Extra Tip: A microfibre towel is even more gentle and can prevent frizz.
STEP 2
Apply to towel-dried hair
Distribute the conditioner across your palms, then apply through the lengths of your hair.
STEP 3
Brush or comb your hair to detangle
Gently does it! Work the conditioner through your hair with a brush or comb – starting with the ends and working your way upwards is the best way to avoid damage or breakage. No need to rinse – your SalonLab&Me Leave-in Conditioner can be left in to keep strands soft and moisturised all day long.
Want to discover more haircare tutorials?
Check out the rest of our How-To's to discover how to get the best out of all your SalonLab&Me products.